The Sycamore, also known as the 'American
Planetree', is found in most of the continental
United States and lower Canada. The Sycamore mostly
grows in temperate lowland areas where high moisture
is prevalent such as streams and marshlands.
Leaf Flake Foliage
is very simple to use and economical when applied
properly. Follow these steps and you'll produce one
of the best looking foreground trees you'll have on
your layout!
1:
Cut a small square approximately 3/4" to 1". Snip
diagonally half way through at several angles.
At one end, pull apart to give a feathered fan shaped appearance with
a "shaggy-end" texture.
The Genius of Silflor has done it again!
Examine this foliage a little closer and you'll
realize that the flakes are actually a five lobed
leaf! Never before has such foliage detail, with
this many seasonal tones, been available to the
average modeler.
2:
Apply Goo II or Quick
Grab adhesive to your branches.
(Spray adhesive works well with fine branch trees like SuperTrees)
Leaf Flake Foliage Set includes one sheet of
leafy foliage on a super-fine polyester branch support.
Sheet measures 6" x 1-1/2" each. Leaves are
colorfast synthetic paper and resist fading and
discoloring.
3:
Gently apply Leaf Foliage to branch with the feathered fan
facing outward. Tease ends to give additional shape.